What command will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server?
- the ip routing command
- the ipv6 unicast-routing command
- a static route
- the ipv6 route ::/0 command
-
Answers Explanation & Hints: The command that will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server is the “ipv6 unicast-routing” command.
This command enables IPv6 unicast routing on a router, allowing it to forward IPv6 packets between networks. It also enables the router to generate link-local addresses using the Router Advertisement (RA) protocol, without the need for an IPv6 DHCP server.
The “ip routing” command is used in IPv4 networks to enable IP routing on a router, while a static route is a manually configured routing entry that specifies the next hop for a particular destination network. The “ipv6 route ::/0” command is used to configure a default route in IPv6 networks.