A new switch is to be added to an existing network in a remote office. The network administrator does not want the technicians in the remote office to be able to add new VLANs to the switch, but the switch should receive VLAN updates from the VTP domain. Which two steps must be performed to configure VTP on the new switch to meet these conditions? (Choose two.)
- Configure the existing VTP domain name on the new switch.
- Configure all ports of both switches to access mode.
- Enable VTP pruning.
- Configure an IP address on the new switch.
- Configure the new switch as a VTP client.
Answers Explanation & Hints: To configure VTP on the new switch to meet the conditions specified, the following steps must be performed:
- Configure the existing VTP domain name on the new switch.
- Configure the new switch as a VTP client.
Explanation:
- To ensure that the new switch receives VLAN updates from the existing VTP domain, the VTP domain name on the new switch must match the VTP domain name on the existing switches in the domain. This can be done by configuring the VTP domain name on the new switch to match the domain name on the existing switches.
- To prevent technicians in the remote office from adding new VLANs to the switch, the new switch should be configured as a VTP client. This means that it will receive VLAN updates from the VTP domain, but it will not be able to add new VLANs to the domain. All ports of both switches should be configured to trunk mode, as this is required for VTP communication between switches.
VTP pruning and IP address configuration are not directly related to the requirements stated in the question and are not required for VTP configuration on the new switch.